feat: icom Scope in Icom Tab

internal/cat/civ/civ.go

@@ -40,7 +40,10 @@ const (
 
 	CmdAtt   = 0x11 // attenuator (1 BCD byte of dB; 0x00 = off)
 	CmdLevel = 0x14 // analogue levels (sub + 2 BCD bytes, 0000-0255)
+	CmdMeter = 0x15 // meters (sub + 2 BCD bytes, 0000-0255): S-meter/Po/SWR
 	CmdSwitch = 0x16 // on/off + multi-state DSP settings (sub + 1 byte)
+	CmdATU    = 0x1C // sub 0x01 = antenna tuner (0x00 off, 0x01 through, 0x02 tune)
+	CmdScope  = 0x27 // spectrum-scope waveform stream (sub 0x00 = data, 0x11 = on/off)
 
 	SubDataMode      = 0x06
 	SubPTT           = 0x00
@@ -48,10 +51,28 @@ const (
 	SubVfoUnselected = 0x01 // CmdVfoFreq: the other VFO (TX in split)
 
 	// CmdLevel sub-commands.
-	SubLevelAF = 0x01 // AF (volume)
-	SubLevelRF = 0x02 // RF gain
-	SubLevelNR = 0x06 // noise-reduction depth
-	SubLevelNB = 0x12 // noise-blanker depth
+	SubLevelAF      = 0x01 // AF (volume)
+	SubLevelRF      = 0x02 // RF gain
+	SubLevelNR      = 0x06 // noise-reduction depth
+	SubLevelNB      = 0x12 // noise-blanker depth
+	SubLevelRFPower = 0x0A // TX RF output power
+	SubLevelMic     = 0x0B // mic gain
+
+	// CmdMeter sub-commands.
+	SubMeterS   = 0x02 // S-meter (RX)
+	SubMeterPo  = 0x11 // power output (TX)
+	SubMeterSWR = 0x12 // SWR (TX)
+
+	// CmdATU / CmdPTT sub-commands.
+	SubATU = 0x01 // antenna tuner (data 0x02 = start tune)
+
+	// CmdScope sub-commands.
+	SubScopeData  = 0x00 // waveform data frame (divided across several frames)
+	SubScopeOnOff = 0x10 // turn the scope display itself on/off (00/01)
+	SubScopeOn    = 0x11 // enable/disable waveform data output over CI-V (00/01)
+	SubScopeMode  = 0x14 // center/fixed mode (0=center, 1=fixed) — VERIFY on rig
+	SubScopeSpan  = 0x15 // span in center mode — VERIFY on rig
+	SubScopeEdge  = 0x16 // fixed-mode edge frequencies — VERIFY on rig
 
 	// CmdSwitch sub-commands.
 	SubSwPreamp = 0x02 // 0=off, 1=P.AMP1, 2=P.AMP2