chore: release v0.22.9

2026-08-02 06:40:10 +02:00
parent 296a4a55c0
commit f6cd6e999a
38 changed files with 1308 additions and 297 deletions
@@ -0,0 +1,47 @@
+# Yaesu (native CAT)
+
+A native backend talks to an **FTDX10 / FTDX101** (and close relatives) directly
+over the rig's USB/serial port — no OmniRig. Pick **Yaesu (USB)** in
+Settings → CAT: COM port + baud (FTDX10/101 default 38400).
+
+Frequency, mode, VFO A/B (MAIN/SUB on the 101), split and PTT are covered, and
+OpsLog **follows the VFO you are actually on** — the displayed frequency, the
+logged frequency and the VFO a cluster spot tunes. Split is worked out from
+which VFO transmits, so simplex on the SUB receiver is not shown as split.
+
+## The Yaesu console
+
+With the native backend connected, a console tab (and a Main-view pane) gives:
+
+- **S / PO / SWR meters** — power in watts on a curve measured against the rig's
+  own display, SWR as the ratio itself, with peak-hold so they stay readable
+  between CW words or SSB syllables.
+- **Band and mode buttons** — CW, RTTY, DIGI and PSK show their sideband; click
+  the active button again to switch it.
+- AF / RF / squelch, AGC, IPO–AMP1–AMP2, 6/12/18 dB attenuator, NB, DNR, narrow
+  filter, power, mic gain, VOX, split and **ATU tune**.
+- **SPLIT** places the transmit VFO up 1 kHz on CW/data, up 5 kHz on phone.
+- In CW the mic gain and VOX give way to a **CW card**: keyer speed, break-in
+  and ZIN (zero-in).
+
+Sliders only respond to the mouse wheel after you click them, so scrolling the
+panel can't change the transmit power by accident.
+
+## CW with the rig's own keyer
+
+A CW engine sends your macros with the radio's internal keyer (CAT `KY`) — no
+WinKeyer, no second cable. Pick **Yaesu (rig keyer)** in Settings → CW keyer.
+
+- Works on the **FTDX101 / FT-991A / FT-710** family.
+- An **FTDX10 does not accept it** (`KY` is refused, `DAKY` doesn't help) —
+  OpsLog says so and points to the **serial DTR keyer** on the rig's second COM
+  port (the *Serial port* CW engine), which works. See [[Audio and Keyers]].
+- CW speed is one setting everywhere: the console slider, the CW panel and the
+  rig's front panel stay in agreement.
+
+## Notes
+
+- A Yaesu that is switched off is reported as such (opening the port is not
+  "connected").
+- If your interface goes into transmit the moment OpsLog connects, enable the
+  **lower DTR/RTS on connect** option — see [[CAT Control]].