chore: release v0.19.2

2026-07-09 16:51:57 +02:00
parent 5ae2bad549
commit 19c2de5f61
37 changed files with 1395 additions and 73 deletions
@@ -0,0 +1,54 @@
+# FlexRadio
+
+When the CAT backend is a **FlexRadio (SmartSDR)**, OpsLog shows a full
+SmartSDR-style control panel (as a Main-view pane or the FlexRadio tab). It talks
+the radio's TCP API directly and streams live meters over UDP (VITA-49).
+
+## Slices (multi-slice)
+
+FlexRadios can run several receiver slices (A/B/C/D…). OpsLog shows **every
+in-use slice** as a row of buttons under the header:
+
+- Click a slice to make it the **active** slice — the main frequency, mode, DSP
+  and spot-clicks all follow it.
+- Click a slice's **TX** badge to move the transmitter onto it.
+- **Split** is detected only when the TX slice and a same-band RX slice form a
+  genuine split; independent slices on other bands are not shown as split.
+
+Everything you do targets the **active** slice, so a second slice monitoring
+another band never hijacks your main frequency.
+
+## Header
+
+Model + RX/TX state, plus compact **PA voltage** and **PA temperature** readouts
+(temperature turns amber/red as it climbs).
+
+## Transmit
+
+RF power, tune power, **TUNE**, **MOX**, **SPLIT**, speech processor (NOR / DX /
+DX+), VOX (+ level + delay), monitor (+ level), mic gain, **TX filter** low/high
+cut, and the **mic profile** selector. On CW the panel switches to keyer controls
+(speed / pitch / break-in / sidetone / filter).
+
+## Receive (active slice)
+
+RX/TX antenna, AGC mode + threshold, audio level, and the noise/notch filters:
+**NB**, **WNB** (wideband noise blanker), **NR**, **ANF**, and **APF** on CW —
+each a toggle plus level. Filter-width presets per mode.
+
+## Amplifier (PowerGenius XL)
+
+If a PowerGenius XL is detected, its **OPERATE / STANDBY**, **fan mode** and
+**fault** show in an Amplifier card, with the amp's FWD / ID / TEMP meters
+inline. See [[Amplifiers and Switches]].
+
+## Meters
+
+Live UDP meters under the slices: **S-meter** (S-units, click → fill RST),
+**forward power** (W), **SWR**, **mic** level (−40…+10 dB, red = overdrive) and
+**compression**. PA voltage and temperature are in the header.
+
+## Antennas per band
+
+Configure Flex **RX/TX antennas per band** (Settings → FlexRadio); OpsLog applies
+them automatically on band change.